free copyright

MyFreeCopyright.com Registered & Protected

Tuesday, September 1, 2009

Wax resist and your C.Bug

All you cuttle bug lovers this is for you...This was taken from splitcoast stampers, as there tutorial was much better than mine. Can find it here

Wax Paper Cuttlebug Resist

by Godelieve Tijskens
Combine Cuttlebug embossing with wax paper resist to create beautiful backgrounds.

Supplies

  • Cuttlebug™
  • Cuttlebug™ folder
  • Glossy cardstock (twice the size of Cuttlebug embossing folder)
  • Wax paper (size of Cuttlebug embossing folder)
  • Dye ink (I used the Fired Brick - Distress Ink from Ranger)
  • Make-up sponge
  • Iron
  • Paper towel or copy paper

Step-by-Step

  1. Step 1

    Emboss the wax paper in the Cuttlebug™ with an Embossing folder of your choice.
  2. Step 2

    Fold the glossy cardstock in half, and put the embossed wax paper inbetween.
  3. Step 3

    Cover the glossy cardstock with copy paper or paper towel, to avoid wax on the iron. Select “cotton” setting on the iron, no steam! Iron the cardstock.

    This will transfer the design from the wax paper on to the glossy cardstock.


  4. Step 4

    Remove and discard the wax paper. Begin sponging the Distress Ink on, using a circular motion. Apply enough ink to get an even color.


  5. Step 5

    Notice a positive and negative pattern, because both sides of the wax paper were used.


  6. Color looks less vibrant after a while.
  7. Step 6

    Finish your card.



1 comment:

linda 430 said...

I can't wait to try this!!!